⎝⎛体育滚球平台⎞⎠

Navigation
⎝⎛体育滚球平台⎞⎠
⎝⎛体育滚球平台⎞⎠
Q & A
contact us
Service Hotline
400-660-1965
Shanghai Qidu Intelligent Technology Co., Ltd. official website
Mobile: 13681711918
Phone: 021-331668782
QQ: 373511263
email: [email protected]
Headquarters Address: Room 201, No. 9, No. 7288, Zhongchun Road
Branch Address: 295 North Songwei Road, Songjiang District
Installation conditions and steps of electric plug lock
Browse: Release Date: 2019-10-15
When installing the access control, the installation of the electric plug lock is an indispensable thing. So what are the conditions for its installation? What is the specific process? Let ’s take a look!


I. Installation conditions:


The difficulty in installing the access control is the installation of the electric lock. The installation of the electric lock is mainly determined by the door. Therefore, the most basic question is, "What kind of door are you?" Simple points can be divided into glass doors, wooden doors / metal doors (anti-theft doors). As long as conditions permit, glass doors are recommended to install "electric plug locks"

Installation steps:


Step 1: Close the door, determine the center line between the door and the door frame, and align the sticker in the lock box with the center point.
Step 2: Make holes in the door frame according to the holes shown on the sticker.
Step 3: Install the lock body on the door frame, attach the bezel, and fix it with screws.
Step 4: Install a lock on the door.
Precautions:
During installation, the lock body (including the lock tongue part) needs to be installed in the spine, and then the lock plate (including the lock hole part) is installed on the upper part of the movable fan. When installing, pay attention to adjusting the corresponding positions of the lock tongue and the lock hole, and the corresponding positions with the floor spring and floor lock.
For framed glass doors, a lock plate is sufficient; but for frameless glass doors, a small door clamp "lower bracket" must be used as the keyhole.

Third, the installation of electric plug lock:


1.Glass doors with edging up and down
The most common way to install an electric mortise lock does not require the use of any additional accessories. The so-called condition means that the vertical thickness of the upper door frame is greater than 4.5 cm.
2. Glass door with upper frame and no lower frame: there is no hemming at the bottom, so the keyhole is fixed with the help of the "lower door clip".
3. Glass door without frame at the top and bottom: the electric plug lock needs to be fixed by means of the "upper door clip", and the lock hole is fixed by the "downper door clip".

Previous: Introduction to the concepts and differences between strong and weak electricity Next: Problem solving methods and maintenance methods of electronic fences